Andrew Streit Resume

ANDREW STREIT

SUMMARY

I am an Electrical Engineering student at Kansas State University with hands-on experience building, wiring, and troubleshooting real hardware. I am currently the Electrical Lead at Pogo Robotics, the Electrical Team Officer with Wildcat Wind Power, and mentor for FRC Team 9445.

EDUCATION

Kansas State University, Manhattan, KS
Expected May 2029
Bachelor of Science in Electrical Engineering | GPA: 3.385
Relevant Coursework: Introduction to Electrical Engineering, Digital System Design, C Programming, Calculus I and II
Bonner Springs High School – Diploma, GPA: 3.94
May 2025

EXPERIENCE

Pogo Robotics – Electrical Lead
Apr 2024 – Present
  • Lead hands-on electrical work on robotic systems, handling wiring, component installation, bring-up, and troubleshooting power and control issues.
  • Work with mechanical and software teammates, so electrical changes fit the rest of the robot and operate reliably.
Chick-fil-A Restaurants
May 2022 – Present
Facility Technician | May 2024 – Present
  • Keep facility equipment working by diagnosing problems, completing repairs, and responding when an issue affects restaurant operations.
Crew Trainer | Aug 2022 – May 2024
  • Continue training new employees and tracking their progress after earning promotions from Crew Member to Crew Trainer and Facility Technician.
Crew Member | Jun 2021 – Aug 2022
  • Supported daily restaurant operations by serving guests, preparing orders, and maintaining food-safety and cleanliness standards in a fast-paced environment.

PROJECTS

WWP Wind Tunnel
May 2026 – Present
  • Designed and built a control board for the Kansas State University WWP wind tunnel to make wind-turbine testing easier to set up and run.
  • Sponsored project by JLC for a YouTube video about upgrading the WWP wind tunnel.
Robotic Mower
May 2026 – Aug 2026
  • Reworked a pull-behind mower into a platform that could drive autonomously using two wheelchair motors and a 24 V electrical system.
  • Integrated the Pixhawk, ArduPilot, motor controllers, and pull-behind mower while troubleshooting PWM, power, and PID issues.
Heat/AC Controller
Dec 2022 – Jun 2023
  • Iterated through hardware revisions, learning version control of designs and change management.
  • Designed PCB in KiCad and developed firmware in C++.

LEADERSHIP AND ACTIVITIES

Wildcat Wind Power – Electrical Team Officer
2025 – Present
  • Build electrical and control systems for team projects, including the Raspberry Pi-based wind tunnel controller and operator interface.
  • Run tests, collect data, coordinate electrical work, and help other members learn the system.
FRC Team 9445 – Brave Bots
2024 – Present
Mentor (2025 – Present) | Team Member (2024 – 2025)
  • Mentor high school students across build, programming, electrical, and design, helping them plan work and solve technical problems.
  • Guide design and integration work, including a 26 x 28 in MK4i swerve chassis, while supporting a program that grew from 13 to approximately 50 members.

TECHNICAL SKILLS

Design and Simulation: KiCad, LTspice, AutoCAD, Autodesk Inventor

Hardware and Controls: Soldering, circuit testing, PCB design, motor controls, sensors, power distribution

Programming and Platforms: C/C++, Verilog, Arduino, Raspberry Pi, Pixhawk, ArduPilot, DE1-SoC FPGA